INSULADD E-COAT IX

Insulating interior/exterior satin finish wall coating.

INSULADD® E-COAT IX  is superior acrylic satin finish insulating paint (Contains INSULADD®) which provides a high performance quality finish as well as the industries highest insulating performance obtained through the inclusion of INSULADD® into the paint formulation.

Uses:
INSULADD® E-COAT IX   is designed to be easily applied to a wide variety of surfaces. Give your home the best ! 

INSULADD® E-COAT IX   will give you years of trouble free beauty.
 Apply in the conventional manner with brush, roller, conventional spray or airless sprayer. Application is identical to ordinary house paint with an average coverage rate of 275 sq.ft. per gallon. A two coat application is recommended for optimum performance and appearance.

Wood doors, siding and trim

Galvanized, bare, or painted, steel and aluminum siding and doors

Drywall and plaster

Masonry, concrete block, and stucco

Cement and clay roof tile

Asphalt shingles

Features:

Provides a thermal insulating barrier that will reduce your home's heating and cooling requirements.
Durable, non-yellowing, colorfast, washable, colorfast satin finish.
Highly resistant to salt spray, air pollution, corrosion & moisture.
Contains safe yet effective Algaecides and mildewcides
Covers small surface imperfections with superior hiding characteristics.
Chemical  and alkali resistant,chemical, high impact resistance to chipping.
Environmentally safe, low VOC, no hazardous pigments .
 
Uses:
Use on a wide variety of surfaces including metal siding, aluminum and wood siding, galvanized metal, drywall, plaster,wood trim, masonry, concrete block, stucco, storage tanks, wood and metal doors, cement roof tile, asphalt roof materials.

Preparation:
All surface defects such as peeling paint, blistered paint, cracks and voids should be corrected before painting.
Mix thoroughly before using!                                                            Be sure the surface is clean, dry and mold, mildew, oil, and wax free before application.

Rusted metal surfaces should be spot primed with a rust inhibiting primer such as zinc chromate prior to application of E-COAT IX.

Exterior wood primer is recommended on new wood and on staining type woods such as redwood, cedar, or mahogany.
 
If slight thinning is necessary thin with water, not exceeding 1 pint per gallon or use our new
 
Allow 2 to 3 hours drying before re-coating.

Cleans up with soap and water !

 Do not apply when surface temperature is below 50 deg. F.
INSULADD® E-COAT IX